Plumber Geelong

How to fix your hot water system Geelong Plumber

Have you run your bath water only to realise its ice cold? Have you jumped in the shower and been sprayed by cold water? If so, chances are you have a problem with your homes hot water system. Don’t stress, there are a few basic things you can try yourself prior to calling a plumber.  If you have a natural or propane gas water system, chances are the pilot has gone out. The pilot is a small flame that ignites the gas burner on your system. When it goes out, first try relighting it, following the directions on the label, which is often on the front of the system. If the pilot doesn’t relight, or if it goes out right after lighting, by far the most common cause is a broken thermocouple. The good news: you can usually replace a thermocouple for minimal cost and in less than an hour from a local hardware. You’ll get your hot water going without waiting for a pro to show up and save a few dollars!

To replace the thermocouple, be sure to turn off the shutoff valve in the gas line; that is, one quarter turn so that the handle is at a right angle to the pipe. Since working room is tight around the burner, we recommend that you simply unscrew the three nuts at the control valve and pull out the entire burner assembly unit. You’ll see either a slot or clips that hold it in its place. Then either unscrew the thermocouple end or pull it out (depending on the water heater) and take it with you to hardware store to find a match. Position it exactly the same way as the old one. The pilot flame should wrap around the thermocouple bulb.

To reattach the three lines to the gas valve, thread the nuts into place with your fingers and hand-tighten them properly. Then snug them up with a quarter to half revolution with a wrench. The metals are soft, so don’t over tighten as they will break.

Be sure to test for gas leaks. You must have the pilot lit and the burner on for this test so that gas is flowing through the large tube on the system. Reopen the shutoff valve, relight the pilot, then turn the control valve to the “on” position. When the gas burner is on, use a 50/50 dish soap/water mix to test the screw joints for air bubbles that indicate leaks.

If you have an issue with a blocked drain geelong or hot water system geelong, then you need a 24 hour plumber geelong or an emergency plumber geelong to service you. You might also reach out to a gas plumber geelong to help you. Its important that you have a plumber geelong or a Geelong Plumber you can trust.

Emergency Plumber Geelong

If you have an issue with a blocked drain geelong or hot water system geelong, then you need a 24 hour plumber geelong or an emergency plumber geelong to service you. You might also reach out to a gas plumber geelong to help you. Its important that you have a plumber geelong or a Geelong Plumber you can trust.

Plumber Geelong Holiday Season Plumbing Tips

Bathroom Plumbing

1. Having guests visiting for the holidays leads to increases in toilet use, so be sure to tell your guests not to put sanitary products, napkins, or baby wipes in the toilet. Not everyone knows that these items belong in the trash and not in the toilet!
2. Ask your guests to use all the toilets in the house to reduce the load on a single toilet and decrease the chance of it getting backed up.
3. Make sure there are no items on top of the toilet tank lid and remove any items you may have hanging near or over the toilet bowl. Guests are not used to the way things are positioned in your home and they may accidentally knock an object into the toilet!
4. In case of a blockage in your toilet, do not keep flushing: use a plunger to try and dislodge the blockage.
5. If your toilet keeps running on, check the position of the flapper inside the tank. It has to fit over the hole in the base of the tank, if it’s not fitting properly, use the shut off valve, which is normally located under the tank.
6. Place hair traps in all showers and tub drains, as you will have extra guests taking showers and that will add to the amount of hair going down the drain.

Kitchen Plumbing

1. A lot of cooking will be happening in your kitchen during the holidays. Make sure that whoever is helping you in the kitchen knows what should go in the trash, what can go in the bio container and what ought to go in the garbage disposal (if you have one).
2. Avoid putting pasta, rice, coffee grounds, bones, potato skins, egg shells, lettuce or any large amounts of food down the garbage disposal.  Remember to run cold water when using it.
3. Be sure to never pour that turkey grease or ham fat down the drain and if you don’t have a garbage disposal make sure you have a strainer in your sinks.
4. If your kitchen sink (or any sinks!) gets blocked use this vinegar and baking soda solution to help unclogged your drain.
5. For dishwashers, make sure you’re removing the food scraps from the dishes and cutlery and rinsing them in the sink so that the debris doesn’t block the dishwasher water line.

If you are having further issues, get in touch with a great plumber from Melbourne 24 Hour Plumbing , Mr Plumber Sydney, Manly Emergency Plumber, Plumber Perth, Plumber Adelaide,Plumber Gold Coast

If you have an issue with a blocked drain geelong or hot water system geelong, then you need a 24 hour plumber geelong or an emergency plumber geelong to service you. You might also reach out to a gas plumber geelong to help you. Its important that you have a plumber geelong or a Geelong Plumber you can trust.

DIY Plumber Tips

Plumbing is a varied and skilled profession that includes many diverse areas of the job. In Melbourne, some plumbing tasks should be left to professional plumbers for reasons of safety and health. Plumbing jobs that entails working on gas channels of inner heating boilers must actually be left for professional heating engineers or gas fitters, as a mistake would cost a person’s life. There are lots of DIY plumbing maintenance that you can perform yourself without exposing yourself in danger.

Watching out your plumbing system may appear like a huge task, maybe even anything that must be left to a professional plumber Melbourne. And whilst this is actually true for a number of projects such as repairing breaks, leaks, cracks, power failure and frozen pipes, there are simple methods that you as the home owner may assist to make sure that your plumbing mechanism runs smoothly. Offering simple repair for your plumbing mechanism will ensure that it is properly maintained, and would hopefully assist to minimize the amount of visits required from an expert plumber to handle larger problems.

For instance, dripping pipes may be irritating to say the slightest, but dripping pipes that are left unattended to for long durations may cause fair amounts of damage to properties. Most drips result from poorly fitted joints of pipes. These pipe joints may be found n several applications that include:

• Bath traps, basin traps and kitchen sinks are all linked to the waste-water pipe by use of a threaded joint; when the joint leaks it may cause damages to units, floors or anything below the joint. The most excellent method to remedy this kind of leak is removing the connecting nuts and ensuring that the rubber washers are present and in perfect conditions. The next measure is making sure that the pipes are pushed completely into the fittings on the traps. A perfect idea is binding the threaded parts of the traps with thread tapes or PTFE to ensure good seals.
• Leaks for mechanical joints or compression joints may also be repaired in a similar manner. Compression joints are usually maintenance free although if they are interrupted the joint may start leaking. If you get one of such joints leaking the most excellent thing to perform is isolating the water and draining the pipe work completely. This may be carried out in most instances by unlocking the taps. Carefully loosen the joint using a spanner; it is an excellent idea to have some kind of towel or container under the joint so that it can capture any residual moisture that might be left inside the pipe work. Fully undo the nut and then join the joint treads with PTFE tape, retighten the nut to complete the repair.

If you have an issue with a blocked drain, blocked drain Sydney or hot water system Sydney, then you need a 24 hour plumber Sydney or an emergency plumber Sydney to service you. You might also reach out to a gas plumber Sydney to help you. Its important that you have a plumber Sydney, plumbers Sydney, Plumbing Sydney or Sydney Plumber you can trust – Mr. Plumber Sydney.